is to attach these items using bungee cords with the
expanded metal. It can also be used to attach extra plow
points for you plow attachment. We have found that it may
be necessary to add extra weight to the unit under certain
situations, especially when discing hard or extremely rough
soils. This will improve the discing and plowing of the unit.
F. An ELECTRIC OR MANUAL JACK is attached to the
wheel assembly. The jack has a 14” vertical travel that gives
plenty of ground clearance. The jack allows you to adjust
how deep you wish to cut by using the wheels as a depth
gauge. For example, if you wish to cut 4” deep, simply raise
the jack or wheel assembly 4’ off the ground. Loading or
pressure can be taken off the discs or plows simply by
lowering the wheels. This will allow you to adjust the
loading for different pulling machines.
To operate the electric jack manually, use a 3/16” allen
wrench to remove the plug in the top of the motor and a
1/4” allen wrench to turn the motor shaft located inside.
WARNINGS!!!
DO NOT pull this unit on a public road or highway! The
wheels on this machine are not intended for road or
highway use.
When coupling the PLOTMASTER™ to the ATV, make
certain the 6 wire cable has enough slack to allow for
turns but not enough to be caught in the harrow discs.
Too much slack will allow the cable to be cut by the discs.
G. The PLOW ATTACHMENT attaches to the
PLOTMASTER™ behind the jack using two hitch pins
located on the side of the main frame. The plow
attachments has four holes for depth adjustments. The two
middle adjustments work best for most applications.
The PLOTMASTER™ is delivered with three (3) plows
attached to the plow attachment and two (2) extra that can
be added to the plow attachment as needed.
Each plow attachment comes with three (3) different types
of plow points.
To Next Page
Loading...