Plotmaster 400 - Seeding and Soil Conditioning; Electric Seeder and Flow Control

1. Five (5) narrow, reversible CHISEL POINTS for hard, rough
soils.
2. Five (5) medium-sized CULTIVATOR POINTS for cultivating
prepared soils.
3. Five (5) 9” SWEEP PLOW POINTS for plowing cultivated soils
with little or no vegetation
(Hint: If plow points load up with vegetation, discing and
plowing are reduced. The points can be cleaned simply by raising
the unit slightly with the jack, backing up and the vegetation will
catch beneath the tires, pulling it away from the plows.)
(Hint: The smaller chisel points work much better than the
larger sweep plows for plowing if vegetation exists. If you are
using five (5) plow points, removing two (2) will allow vegetation
to flow through without clogging up. You can also remove the
entire plow attachment if plow points continue to load up or
collect too much vegetation.)
The plow attachment can be replaced with many different
attachments. Some of the attachments are listed as “Other
Attachment” on the following pages. To replace the plow
attachment with another attachment, simply remove the hitch
pins and raise your PLOTMASTER™ to drop the plow
attachment out. Slide new attachment in place, lower the
PLOTMASTER™ so attachment arms slide in same receivers
on the outside of the main frame. Adjust to desired holes and
then replace hitch pins.
H. Each of the units comes with an ELECTRIC SEEDER to
distribute and plant seed. The seed flow control is attached
directly to the seed gate. There are 12 detents (notches) that
determine the amount of opening of the seed drop holes in the
bottom of the seeder. Adjust the seed flow control for the size
seed being dispensed. See notes.