Plus P-106A - Error Code

20 21
PROCEDURE FOR REMOVING
THE CAUSE OF ERROR
DISPLAY
No
Check the encoder sensor or Encoder Wheel.
Check the gab between feeding Rollers on the
hopper position and adjust the gab with
thickness adjustment screw to feed the notes
smoothly. Change the density level.
Remove suspected note.
Remove suspected note.
Remove suspected note.
Turn off the power and clean each sensor with
enclosed brush or remove something to be
stuck on the sensor
SH
db
Sd
(
OPTION
)
FC
(
OPTION
)
CF
(
OPTION
)
Str ~ Enco
󳞇
󳞈
󳞉
󳞊
󳞋
󳞌
TYPE OF
ERROR
Short note
Double
detection
error
Different
denomination
FAULT CASH
Counterfeit
Failure of
SENSOR
(
S
)
CAUSE OF
ERROR
Thickness gab or
density level is not
proper
A suspected different
denomination
note was detected
(
Sd detection
)
A suspected
counterfeit note
was detected.
(
UV detection
)
A suspected
counterfeit note
was detected.
(
MD detection
)
Sensor is dirty or
something is stuck
on the sensor
7. ERROR CODES
PROCEDURE FOR REMOVING
THE CAUSE OF ERROR
DISPLAY
No
1. Remove notes placed in the hopper and / or
stacker.
2. Open the upper part of the hopper and remove
the jammed note
(
s
)
.
3. Restart counting operation after clearing the
error by ⓒ key.
4. Check the gab between feeding Rollers on the
hopper position and adjust the gab with
thickness adjustment screw to feed the notes
smoothly.
JAn
󳞄
TYPE OF
ERROR
Jam
CAUSE OF
ERROR
Note is jammed in
the machine.
When an error occurs, error code will be displayed. Confirm the problem indicated by the error
code and try to remove the error according to the following procedures.
Remove all the notes from the hopper.
Check the gab between feeding Rollers on the
hopper position and adjust the gab with thickness
adjustment screw to feed the notes smoothly.
HF
CHn
󳞅
󳞆
Half note
Chained note
Abnormal note is
mixed in the bundle of
notes to be counted.