w Standard current signals 0...20mA: I0-20 or 4...20mA : I4-20
w This signal can be linearized according to thermocouple or Pt100 curves.
If linearization is not required noLin must be selected.
w Temperature unit in Celsius !C or in Fahrenheit !F
w Reaction with current signal <2mA (only with 4..20mA)
S_UP = action as input value higher than display range, 99999 blinking
S_do = action as input value lower than display range, 00000 blinking
w Adaption to the transmitter,
span start 0"o and span end 100!o, e.g. 200(°C) to 600(°C).
w U_1 = standard signal 0...10V. For description, see standard current
signals
w All other measuring ranges are free voltage measuring ranges, from which
the required measuring range can be selected.
U_2
0...5V
U_3
0...1V
U_4
0...500mV
U_5
-10...50mV
U_6
-10...20mV
U_7
-10...15mV
w In 1 = span start x
0
in mV and
Out 1 = start of display range w
0
w In 2 = span end x
100
in mV and
Out 2 = end of display range w
100
w r_1 = measuring range 0...180W, r_2 = 0...450W .
w In 1 = span start x
0
in W and
Out 1 = start of display range w
0
w In 2 = span end x
100
in W and
Out 2 = end of display range w
100
.
w Reaction with sensor break:
S_UP = action as input value higher than display range, 99999 blinking
S_do = action as input value lower than display range, 00000 blinking
8
9499-040-24701
To Next Page
Loading...
Need help?
General