PNI CT60 - Setting the time and day of the week; Operation mode setup

6
will turn o. Turn on the transmitter unit. If the set
temperature is higher than the room temperature, the
transmitter unit will send an RF signal to the receiver
unit, which, in turn, will send a ON command to the
boiler. In this situation, LED 1 (red) will remain lit.
Set the time and day of the week
Hold down the MENU key for 3 seconds. The minute
indicator will flash. Use the ▲ and ▼ keys to reach the
desired value. Briefly press the MENU key to confirm
and move to the time setting. The time indicator will
flash. Use the ▲ and ▼ keys to reach the desired value.
Briefly press the MENU key to confirm and move to
the day of the week setting (1 to 7). Press the MENU
key to exit.
Operation mode setup
Briefly press the MENU key to set the operation mode:
Scheduled, Manual or Holiday.