Pocket Wizard Plus II - Batteries and Mounting Options; Battery Installation and Life; Mounting Methods

4
5
For attaching to
flashes, brackets,
cameras, etc.
See NOTE 2.
VELCRO
®
For tripods,
mounting arms,
isolation bars,
brackets, etc.
1/4-20 Mount
For mounting on
a bracket shoe, cold
or dead shoe, etc.
For hanging from a
light stand, flash handle,
tripod knob, belt, etc.
Lanyard
Shoe Mount
BATTERIES
CAUTION: Turn OFF your equipment (PocketWizard units,
electronic flash units, cameras, etc.) before making connections
or changing batteries.
Install 2 fresh AA (IEC:LR6) batteries into the Plus II Transceiver.
Make sure to note proper polarity. Alkaline batteries are recommended.
Rechargeable batteries will also work, though operation time may be reduced.
When the STATUS LEDs stop blinking, it is time to change the batteries.
Battery life is approximately 60 hours under typical use.
See NOTE 1 for more battery information.
WARNING – To avoid battery leakage, follow these guidelines:
• Always remove the batteries when the unit is not in use for extended periods of time,
or during shipping or long distance travel.
• Never mix old and new batteries. Always use a fresh pair of matched batteries.
• Always change batteries promptly at the first indication of low battery operation.
• Do not use or leave the unit in extreme temperature or humidity situations.
See “Technical Information” for normal operating and storage temperatures.
MOUNTING
Mount a remote Plus II Transceiver using any of the included methods.
See “Sustaining High Performance” for more mounting information.