ordinary supply hose
safety supply hose
About the safety supply hose
The safety supply hose consists of the double walls. The hose's system
guarantees its intervention by blocking the flow of water in case of the
supply hose breaking and when the air space between the supply hose itself
and the outer corrugated hose is full of water.
WARNING
A hose that attaches to a sink spray can burst if it is installed on the same
water line as the dishwasher. If your sink has one, it is recommended that
the hose be disconnected and the hole plugged.
How to connect the safety supply hose
1. Pull the safety supply hoses completely out from storage compartment
located at rear of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread
3/4inch.
3. Turn water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn o the water.
2. Unscrew the safety supply hose from the faucet.
Connection Of Drain Hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm,
or let it run into the sink, making sure to avoid bending or crimping it. The
height of drain pipe must be less than 600mm. The free end of the hose
must not be immersed in water to avoid any back flow occurring. Securely
fix the drain hose in either position A or position B
.
19
To Next Page
Loading...
