17
INSTALLATION INSTRUCTION
WARNING
Electrical Shock Hazard
Disconnect electrical power before installing dishwasher.
Failure to do so could result in death or electrical shock.
Attention
The installation of the pipes and electrical equipments should be done by
professionals.
About Power Connection
WARNING
For personal safety:
Do not use an extension cord or an adapter plug with this appliance.
Do not, under any circumstances, cut or remove the earthing connection
from the cable.
Electrical requirements
Look at the rating label to know the rating voltage and connect the
dishwasher to the appropriate power supply. Use the required fuse
10A/13A/16A, time delay fuse or circuit breaker recommended and provide
separate circuit serving only this appliance.
Electrical connection
Ensure the voltage and frequency of the power being corresponds to those
on the rating plate. Only insert the plug into an electrical socket which is
earthed properly. If the electrical socket to which the appliance must be
connected is not appropriate for the plug, replace the socket, rather than
using a adaptor or the like as they could cause overheating and burns.
Ensure that proper earthing exists before use.
Water Supply And Drain
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and
make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of
time, let the water run to make sure that the water is clear. This precaution
is needed to avoid the risk of the water inlet to be blocked and damage the
appliance.
To Next Page
Loading...