2. If dishwasher is in stalled at the corner of the cabinet,
CabinetDishwasher
Door of
dishwasher
Minimum space
of 50mm
there should be some space when the door is opened.
NOTE:
Depending on where your electrical outlet is, you may
need to cut a hole in the opposite cabinet side.
Step 2. Dishwasher installation steps
1. Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface.
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position.
6. Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher by
turning the Philips screw in the middle of the base of dishwasher using an Philips
screw. To adjust the front feet, use a flat screw driver and turn the front feet until the
dishwasher is level.
7. Adjust the tension of the door springs by using an Allen key turning in a clockwise
motion to tighten the left and right door springs. Failure to do this could cause damage
to your dishwasher.
8. The dishwasher must be secured in place. There are two ways to do this:
A. Normal work surface: Put the installation hook into the slot of the side plane and
secure it to the work surface with the wood screws.
B. Marble or granite work top: Fix the side with screw.
A
B
22
To Next Page
Loading...
