EasyManua.ls Logo

point PTD47W20 - Page 14

point PTD47W20
204 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1514
1. To remove the spray arm, pull out
the spray arm upwards.
2. Wash the spray arm in soapy and
warm water and use a soft brush
to clean the jets. Replace them
after rinsing them thoroughly.
Caring For The Dishwasher
Frost precaution
Take frost protection measures on the dishwasher in winter. Every after
washing cycles, operate as follows:
1. Cut off the electrical power to the dishwasher at the supply source.
2. Turn off the water supply and disconnect the water inlet pipe from the
water valve.
3. Drain the water from the inlet pipe and water valve. (Use a pan to gather
the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up
water in the sump.
After every wash
After every wash, turn off the water supply to the appliance and leave the
door slightly open so that moisture and odors are not trapped inside.
Remove the plug
Before cleaning or performing maintenance, always remove the plug from
the mains power socket.
No solvents or abrasive cleaning
To clean the exterior and rubber parts of the dishwasher, do not use
solvents or abrasive cleaning products. Only use a cloth with warm soapy
water. To remove spots or stains from the surface of the interior, use a
cloth dampened with water an a little vinegar, or a cleaning product made
specifically for dishwashers.

Related product manuals