3736
Starting A Cycle Wash
1
. Draw out the basket, load the dishes and push them back.
2. Pour in the detergent.
3. Insert the plug into the mains power socket. The power supply refer to
last page "Product fiche". Make sure that the water supply is turned on to
full pressure.
4. Close the door, press the Power button, to switch on the dishwasher.
5. Choose a program, the response light will turn on. Then press the Start/
Pause button, the dishwasher will start its cycle.
Changing The Program Mid-cycle
A wash cycle can only be changed if it has been running for a short
time otherwise, the detergent may have already been released and the
dishwasher may have already drained the wash water. If this is the case, the
dishwasher needs to be reset and the detergent dispenser must be refilled.
To reset the dishwasher, follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Press Program button for more than 3 seconds - the program will cancel.
3. Press the Program button to select the desired program.
4. Press the Start/Pause button, after 10 seconds, the dishwasher will
start.
3 sec
To Next Page
Loading...
