33
Adjusting the rinse aid reservoir
Adjust lever (Rinse)
The rinse aid reservoir has six settings. Both
therecommended setting and the factory setting
is “4”. If the dishes are not drying properly or are
spotted, adjust the dial to the next higher number
until your dishes are spot-free.
Reduce it if there are sticky whitish stains on your
dishes or a bluish film on glassware or knife blades.
Filling The Detergent Dispenser
Push latch to open
1. Press the release catch on the
detergent dispenser to open the
cover.
2. Add detergent into the larger
cavity (A) for the main wash cycle.
For more heavily soiled wash
loads, also add some detergent
into the smaller cavity (B) for the
pre-wash cycle.
3. Close the cover and press on it
until it locks into place.
NOTE:
z
Be aware that depending on the soiling of water, setting may be
different.
z
Observe the manufacturer's recommendations on the detergent
packaging.
To Next Page
Loading...
