the water valve.
3. Drain water from the inlet pipe and water valve (use a pan to catch
the water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to
soak up water in the sump.
NOTE:
If your dishwasher cannot work because of the ice, contact an
authorised service person.
Cleaning the spray arms
The spray arms can be easily removed for periodic cleaning of the
nozzles to prevent possible clogging. Wash them under running water
and carefully repla
ce them in their seats, checking that their rotary
movement is in no way impeded.
Grasp the middle of the spray arm, pull it upwards to remove it.
Wash the arms under a jet of running water and replace it carefully
to its seat. After reassembly, check that the spray arms rotate freely.
Otherwise, check that they have been installed correctly.
26
To Next Page
Loading...
