13
USING YOUR DISHWASHER
NOTE:
If your model has no water softener, you may skip this section.
Loading salt into the softener
Always use salt intended for use with a dishwasher. The salt container
is located beneath the basket and should be filled as follows:
WARNING
z
Only use salt specifically designed for dishwasher use! Every other
type of salt not specifically designed for dishwasher use, especially
table salt, will damage the water softener. In case of damages
caused by the use of unsuitable salt the manufacturer does not give
any warranty nor is liable for any damages caused.
z
Only fill with salt before running a cycle. This will prevent any grains
of salt or salty water, which may have been spilled, remaining on
the bottom of the dishwasher for any period of time, which may
cause corrosion.
A. Remove the basket and then unscrew and remove the cap from the
s
alt container.
B. Before first wash, add 1L of water in the salt container of your
dishwasher.
C. Place the end of the funnel (excluded) into the hole and introduce
about, 0.13kg of salt. It is normal for a small amount of water to
come out of the salt container.
D. After filling the container, screw the cap tightly back clockwise.
E. Usually, the salt warning light will be cease to be illuminated
within
2-6 days after the salt container has been filled with salt.
F. Immediately after filling the salt into the salt container, a washing
program should be started (suggest choose rapid program).
To Next Page
Loading...
