Electrical Connection
Ensure the voltage and frequency of the power being corresponds
to those on the rating plate. Only insert the plug into a mains power
socket which is earthed properly. If the electrical socket to which the
appliance must be connected is not appropriate for the plug, replace
the socket, rather than using a adaptor or the like as they could cause
overheating and burns.
Ensure that proper earthing exists before use
Water Connection
Connect the cold water supply hose to a threaded
3/4(inch) connector and make sure that it is
fastened tightly in place. If the water pipes are new
or have not been used for an extended period of
time, let the water run to make sure that the water
is clear and free of impurities. If this precaution is not taken, there is a
risk that the water inlet can get blocked and damage the dishwasher.
NOTE:
If the supplied hose close not fit your tap, contact your local plumbing
supply center where adapters are available for purchase.
Connection of drain hoses
Fix the drain pipe with the back pipe of the dishwasher. The interface
is fitted with clamps and tightened with a screwdriver.
Rubber
stopper
Or
Fix drainage pipe with siphon cup
The connection of the drain pipe: Put end of the drain into a sink or
bucket.
To Next Page
Loading...