9
QUICK USER GUIDE
Read the corresponding content on the instruction manual for more
detailed instructions.
Connected to power supplies
The power supply is 220-240VAC 50 Hz
The specification of the socket is 10 A 250 VAC
The connection of the drain pipe: Put end of the drain into a sink or
bucket. Fix the drain pipe with the back pipe of the machine. The
interface is fitted with clamps and tightened with a screwdriver.
Rubber
Or
Fix the drainage pipe to the suction
cup (In the figure)
Adding water into the dishwasher’s tank
Note: Before adding water, you need to
press the power button to turn on the
dishwasher
There are two ways to add water into
the tank:
1. Connect inlet hose to the tap;
2. Open the cap and add water into the
dishwasher’s tank manually
When the tank is full of water, the dis
washer will beep for 3 seconds.
Removing large residue
Remove the large residue before placing.
Drain Pipe
Power cord
Water Inlet
or
To Next Page
Loading...