2.11
MAINTENANCE
2
Lubrication Components
* More often under severe use, such as operated in water or under severe loads.
1 Semi-annually or 50 hours of operation (refer to Maintenance Schedule for additional information)
More often under severe conditions (operating in water or hauling heavy loads)
2 Annually or 100 hours of operation (refer to Maintenance Schedule for additional information)
More often under severe conditions (operating in water or hauling heavy loads)
3 Grease conforming to NLGI No. 2, such as Polaris Premium All Season Grease, Conoco Superlube M or
Mobilegrease Special
#I
TEM LUBE METHOD
FREQUENCY*
1. Engine Oil Polaris 0W/40
Check dipstick and add to
proper level.
Change after 1st month, 6 months, or 100
hours thereafter; Change more often (25-50
hours) in extremely dirty conditions, or short
trip cold weather operation.
2. Transmission
Polaris AGL Synthetic
Gearcase Lube
Add lube to bottom fill hole.
Change annually
o
3A.
3B.
Front Gearcase
ADC Fluid
Demand Drive LT
Premium
Polaris ADC Hydraulic
Drain completely. Add lube to
specified quantity.
Gearcase - Change annually
o
ADC - Change fluid every 2 years
4. Rear Gearcase ATV Angle Drive Fluid
Drain completely. Add lube to
specified quantity.
Change annually
o
5. Brake Fluid Polaris Dot 3 Brake Fluid
Fill master cylinder reservoir
to indicated level
As required, change fluid every 2 years
6. Front A-Arm Polaris All Season Grease Locate fitting and grease.
Semi-annually
n
7. Rear A-Arm Polaris All Season Grease Locate fitting and grease
Semi-annually
n
5. Front Propshaft
Polaris U-Joint Grease
p
Locate fitting and grease.
Semi-annually
n
1. Engine Oil
2. Transmission Fluid
4. Rear Gearcase
3. Front Gearcase
5. Brake Fluid
6. Front A-Arm
7. Rear A-Arm
8. Front Propshaft
To Next Page
Loading...
