64
MAINTENANCE AND LUBRICATION
Engine Oil
Oil Pump Priming (2x4, 4X4)
This priming procedure must be
performed whenever the oil hose
connection between the oil tank
and pump inlet has been
disconnected.
1. Clamp or pinch off the vent
line (1) approximately 2I
from the oil tank (2), between
the end of the oil tank vent
fitting and the vent line’s
pressure relief slit (3).
2. Run the engine for 15-20 seconds.
3. Remove the vent line clamp.
The oil pump will now be
properly primed and ready for
operation.
2I
1
2
3
To Next Page
Loading...
