53
THE PERFECT FIT
Handlebar Adjustment
Standard Handlebars
Follow these steps to adjust the handlebars for a personal fit.
1. Remove the handlebar cover to
expose the handlebar and the four
adjuster block bolts (A).
2. Using a 7/16 ″ (11 mm) wrench,
loosen the four nuts on the bottom of
the adjuster block (turn handlebar to
left or right for access to back nuts).
NOTE: It may be necessary to pry the
adjuster blocks apart with a screw driver.
3. Adjust the handlebar to the desired height. Be sure handlebars, brake
lever and throttle lever operate smoothly and do not hit t he gas tank,
windshield or any other part of the machine when t urned fully to the
left or right.
4. Torque the handlebar adjuster block bolts to 11-13 ft. lbs. (15-17.6
Nm).
5. Replace the handlebar cover.
A
To Next Page
Loading...
