37
FEATURES
Instrumentation
MFD Settings
The MFD control switch allows you
to set the MFD display to your pref-
erences. The rocker switch has a
MODE button (top) and a SET but-
ton (bottom). Specific instructions
are outlined on the following pages.
Standard vs. Metric
The MFD will display either stan-
dard or metric units of measurement.
While viewing a screen that displays
measurements (MPH, km/h or tem-
peratures), press and hold the MODE switch until the unit of measure-
ment changes (about 10 seconds).
To Next Page
Loading...
