96
MAINTENANCE
Cooling System
Coolant
The coolant supplied in the system at the factory is a 50/50 mixture of
ethylene-glycol and distilled water, which will provide adequate freeze
protection under most conditions. If the vehicle will be stored or oper-
ated at extremely low temperatures, greater protection may be required.
Please see your Polaris dealer.
When adding or changing coolant, Polaris recommends using Premium
60/40 anti-freeze coolant, which is already premixed and ready to use.
Do not dilute with water. Never exceed a 60% antifreeze/40% water
mixture. See page 118 for the part numbers of Polaris products.
Tip: Never add tap water to the cooling system. Minerals cause deposits and
may react adversely with the metals in the engine and cooling system.
n Coolant Level
The engine coolant level is controlled by the recovery system. The
recovery system components are:
• Coolant reservoir bottle
• Filler neck
• Pressure cap
• Connecting hoses
Always maintain the coolant level at the “COLD FILL” mark on the
coolant overflow tank (when the engine is cold).
NOTICE: Operating the snowmobile with insufficient coolant will result in
overheating and serious engine damage. Always maintain the coolant
level as recommended.
To Next Page
Loading...
