86
MAINTENANCE
Cooling System
Coolant
The coolant supplied in the system is a 60/40 mixture of ethylene-glycol
and distilled water. This mixture provides protection against freezing.
Contact your dealer if greater protection is required.
Use POLARIS Antifreeze 60/40 Premix. POLARIS Antifreeze is
already premixed and ready to use. Do not dilute with water. Never
exceed a 60% antifreeze/40% water mixture. See page 116 for the part
numbers of POLARIS products.
Tip: Never add tap water to the cooling system. Minerals cause deposits and
may react adversely with the metals in the engine and cooling system.
Use of a non-standard pressure cap will not allow the recovery system to
function properly. If the pressure cap needs replacement, contact your
dealer for the correct part.
CAUTION! Steam and hot liquids will cause burns to your skin. Never remove
the pressure cap when the engine is warm or hot.
Coolant Level
The engine coolant level is controlled by the recovery system. The
recovery system components are:
• Coolant recovery bottle
• Coolant reservoir
• Pressure cap
• Connecting hoses
Always maintain the coolant level at the “COLD FILL” mark on the
coolant recovery bottle (when the engine is cold).
NOTICE: Operating the snowmobile with insufficient coolant will result in
overheating and serious engine damage. Always maintain the coolant
level as recommended.
To Next Page
Loading...
Need help?
General
