97
MAINTENANCE
Clutch System
Drive Belt Adjustment
1. Install the L-wrench into the open threaded hole in the outer sheave
of the clutch (see page 98). Turn the wrench clockwise slightly to
remove pressure from the sheaves.
2. Loosen the 7/16-inch jam nut.
3. Using a 1/8-inch Allen wrench, aturn the set screw inward (clock-
wise) to increase the distance between the sheaves or outward
(counterclockwise) to decrease the distance.
4. Tighten the jam nut. Remove the L-wrench and store it in the tool
kit.
To Next Page
Loading...
