38
FEATURES
Instrumentation
Gauge Cleaning
1. Wipe the gauge face as needed using a clean cloth and a mild soap
and water solution. Wipe dry with clean, soft cloth.
2. Clean the back side of the gauge using a clean cloth and a mild soap
and water solution. Do not remove the electrical connectors or
protective rubber boot. Do not spray the back side of the gauge or
the wire harness with a pressure washer or other water source.
NOTICE: To prevent damage to the lens, do not use alcohol for cleaning. Do not
allow chemicals or sprays to contact the lens. Immediately clean off
any gasoline that splashes on the gauge during refueling.
To Next Page
Loading...
