65
OPERATION
Electronic Reverse (PERC)
Engaging Reverse
1. Stop the snowmobile and leave the
engine idling.
2. Make sure the area behind your
snowmobile is clear.
3. Push the reverse button on the left-
hand control for one second, then
release. The engine will automatically
reduce RPM and start a reverse
rotation.
TIP:A reverse light on the instrument panel will indicate that the transmission is
in reverse.
4. Apply the throttle slowly to make sure the transmission is in
reverse.
TIP:If the engine stops running, the snowmobile will be in forward gear when it's
restarted.
Disengaging Reverse
1. Stop the snowmobile and leave the engine idling.
NOTICE: Engaging the starter when the engine is running WILL result in serious
engine damage, especially if the transmission is in reverse. Never
engage the starter when the engine is running.
2. Push the reverse button for one second and release. The engine will
slow and begin to rotate forward. The light on the instrument panel
will shut off.
3. Apply the throttle slowly to make sure the transmission is in
forward.
To Next Page
Loading...
