87
MAINTENANCE
Lights
Removing Halogen Bulbs
Do not touch a halogen bulb with bare fingers. Oil from skin leaves a
residue, causing a hot spot that will shorten the life of the lamp. If fin-
gers do touch the bulb, clean it with an alcohol-moistened towel.
1. Remove the plenum cover-
ing from the headlight
assembly.
2. Lift the rubber boot to
expose the bulb.
3. Push down on the spring to
release it from the housing.
4. With the wire harness
attached to the bulb,
withdraw the bulb from the
housing.
5. Grasp the bulb by its metal base and carefully separate the bulb
from the harness.
Installing Halogen Bulbs
1. Hold the bulb by its metal base and install it into the wire harness.
2. Insert the bulb into the housing.
3. Connect the spring to the housing.
4. Carefully flip the spring back into the housing, placing it around the
wire harness.
5. Reinstall the plenum covering on the headlight assembly.
6. Adjust headlight aim. See page 28.
Replacing Taillight Bulbs
1. Remove the screws securing the tail-
light lens.
2. Remove the bulb and install a new
bulb.
3. Reinstall the lens.
To Next Page
Loading...
Need help?
General
