Polaris 600 RMK

Questions and Answers:

A
afowlerSep 2, 2025
What to do if my Polaris Snowmobile machine fails to move?
- H
  Harry CruzSep 2, 2025
  If the machine fails to move, the issue could be a jammed clutch. Check for a twisted belt or broken spring. It is suggested to seek assistance from your dealer. Alternatively, the track might be jammed due to a foreign object or the slide melted to the track clips because of lack of lubrication. The track could also be iced up or frozen to the ground. Lastly, the chaincase sprocket or chain might be jammed or broken; the chain could be loose or broken, or the chain tightener might be loose. It is suggested to seek assistance from your dealer.
L
lowesherrySep 3, 2025
Why is my Polaris Snowmobile steering heavy?
- D
  Dawn GonzalezSep 3, 2025
  Heavy steering can arise from damaged skags and skis or binding front suspension shafts and steering components. Ensure you grease all pivot points after elevating the front of the machine. Also, verify the sag dimension, adjusting torsion spring blocks or installing optional torsion springs to achieve the correct sag dimensions. Decreasing IFS preload (premium only) might also help.
J
Jeffrey WoodSep 4, 2025
Why is my Polaris Snowmobile drive belt turning over?
- J
  johnsondavidSep 4, 2025
  A drive belt turning over can be due to using the wrong belt for the application, in which case you should replace the drive belt. It could also be caused by clutch alignment being out of specification, or a broken or loose engine mount. For clutch alignment issues or engine mount problems, it is suggested to seek assistance from your dealer.
M
Monica KlineSep 5, 2025
How to fix harsh drive clutch engagement on my Polaris Snowmobile?
- T
  thompsonbrandonSep 5, 2025
  Harsh drive clutch engagement can be caused by a drive belt that is worn or too narrow; replace the drive belt in this case. Excessive belt/sheave clearance can also be a factor, and it is suggested to seek assistance from your dealer.
J
James WashingtonSep 5, 2025
What causes poor low RPM performance in Polaris 600 RMK Snowmobiles?
- J
  Justin MarshSep 6, 2025
  Poor low RPM performance can result from a worn drive belt, so inspect and replace it as needed. Excessive belt/sheave clearance, a loose torque stop, or a sticky clutch could also be to blame. Inspect and adjust the torque stop if it is loose. Additionally, poor fuel quality can contribute, so use 87-91 octane fuel (or higher). For excessive belt/sheave clearance or sticky clutch, it is suggested to seek assistance from your dealer.
B
Benjamin HallSep 6, 2025
What to do if my Polaris Snowmobile front end pushes?
- T
  Tina JohnsonSep 7, 2025
  A front end push can be due to worn skags or binding front suspension shafts and steering components. Grease all pivot points after elevating the front of the machine. Verify the sag dimension, adjusting torsion spring blocks or installing optional torsion springs to achieve correct sag dimensions. Increase IFS preload (premium only) and move the limiter strap on the front torque arm to the high position.