40
FEATURES
Instrument Cluster
Rider Information Center
Security System (Ignition Lock System)
Locking the System With Your Personal Security Code
1. Start the engine and lock the parking brake.
2. Press and hold the MODE and SEL buttons
for 3 seconds, then release. SECURE OFF
should be displayed. If not, repeat this step.
3. Wait until ENTER CODE displays, then
press and release SEL to advance the digit.
When the first digit of your security code is
displayed, press and release MODE to
accept the digit.
TIP:If the ENTER CODE screen exits due to inactivity,
repeat step 2.
4. Continue to use SEL and MODE to select
and accept the remaining two digits of the
code.
5. After accepting the third digit, view the dis-
play screen. SECURE ON displays if the
system locks. Engine speed is now limited
and the snowmobile cannot be driven.
TIP:When the engine is running, the display will alter-
nate between SECURE ON and ENTER CODE.
6. If BAD CODE displays, the screen will then
return to the ENTER CODE screen. Repeat
steps 3-5 to re-enter the security code.
To Next Page
Loading...
Need help?
General
