Polaris 800 RMK User Manual

101
MAINTENANCE
Clutch System
Drive Belt Condition
Periodically check the condition and tension of the drive belt. Inspect
the belt for signs of excessive wear (frayed edges, missing cogs, cracks)
and excessive looseness. Replace the belt if any of these conditions
exist.
Always carry a spare drive
belt. Store the spare belt in
the belt clip located under
the left side of the hood.
For improved drive-away during extremely cold temperatures, remove
the belt and warm it to room temperature. Reinstall it before starting the
snowmobile.
QUICKDRIVE Belt Condition (PRO RMK)
Periodically check the condition of
the QUICKDRIVE belt. Inspect the
belt for signs of excessive wear,
frayed edges, missing cogs and
cracks.
Replace the QUICKDRIVE belt
every 2000 miles (3200 km) and
whenever inspection reveals
excessive wear or damage. Special
tools are required to remove and
install the QUICKDRIVE belt. Please
see your POLARIS dealer for this
service, or refer to the instructions
provided with the purchase of a new
belt.
Improper track tension can result in
track ratcheting, which will affect
QUICKDRIVE belt durability.
Always maintain proper track tension.
See page 106.

Polaris 800 RMK Specifications

General

Bore x Stroke	85 mm x 70 mm
Engine Stroke	2-Stroke
Rear Suspension	RMK Adjustable
Track Width	15 inches
Track Length	155 in (393.7 cm) / 163 in (414 cm)
Track Height	2.4 inches
Fuel Capacity	11.5 gallons
Engine	Liberty 800
Rear Travel	16 in (40.6 cm)
Displacement	794cc