67
OPERATION
Break-In Period
Drive Belt/QUICKDRIVE Belt Break-In
The length of the break-in period varies depending on the type of drive
system. The break-in period for a new drive belt is 30 miles (48 km).
The break-in period for a new QUICKDRIVE belt is 100 miles (160
km).
• Vary the throttle position and limit full throttle use.
• Always take time to warm up the belt and driveline prior to operating
the snowmobile. Free the track and skis from the ground before
engaging throttle.
Break-In Requirements Specific to the QUICKDRIVE Belt
• During the 100 miles (160 km) of belt break-in, the rider will hear a
sound made by the drive system. After the break-in period, the sound
will become similar to that of a traditional chaincase.
• Improper track tension can result in track ratcheting, which will affect
QUICKDRIVE belt durability. Always maintain proper track tension.
See page 106.
• During the break-in period, this belt sheds a fiber-type material in and
around the drive system. Use a dry shop towel to clean the residue.
• Stop occasionally and allow the snowmobile to cool after high
throttle/high track load events. This will help the QUICKDRIVE belt
achieve maximum performance and it will also break in the engine,
drive belt and sprockets properly.
• On-trail break-in should be performed at speeds no more than 50
MPH (80 km/h).
• Always be cautious when jumping and landing a snowmobile. Avoid
“power-on” landings. Damage caused to any component due to
improper use or abuse is not covered by warranty.
To Next Page
Loading...
Need help?
General
