96
OPERATION
Emergency Stopping
The following chart lists methods for stopping the snowmobile in the
event of an emergency. See page 92 for more information about the
engine stop switch and throttle safety switch.
Daily Storage
At the end of each ride, park the snowmobile on a level surface and
support it at the rear with an appropriate track stand. The track should be
suspended approximately 4 inches (10 cm) off the ground.
Remove the key and cover the snowmobile.
Towing
NOTICE: This snowmobile is not designed for towing disabled snowmobiles or
other objects. Do not tow with this snowmobile. Damage will occur.
If the snowmobile becomes inoperable and must be towed, and if it isn't
possible to use a rigid tow bar, attach the tow rope to the ski spindles
(not to the ski loops) to prevent damage to the steering components.
Remove the drive belt before towing, and have someone ride on the
towed snowmobile to operate the brake and steering when necessary.
NOTICE: Towing a disabled snowmobile with the drive belt in place can result in
serious damage to the engine and drive system. Always remove the
drive belt from a disabled snowmobile before towing.
SYSTEM WHAT IT DOES
Ignition Switch Interrupts ignition circuit
Brake Slows jackshaft
Engine Stop Switch Interrupts ignition circuit
Throttle Safety Switch Interrupts ignition circuit
Tether Switch (Option) Interrupts ignition circuit
To Next Page
Loading...
Need help?
General
