38
FEATURES
MFD Digital Display Prog rams
History Program
Service Interval Reminder
The gauge logs the number of engine
hours between service reminders.
When the logged hours reaches the
designated service interval (set by the
user), the gauge provides a reminder
that service is due. “SErVCE” will
flash in the odometer area and “ENG”
will flash in the icon area for five
seconds each time the vehicle is
started until the service reminder is reset.
To reset the reminder at the existing interval:
1. Enter the service i nterval screen.
2. P ress and hold the SET button for ten seconds, continuing to hold
even after the display begins to flash.
3. When the display stops flashing, release the button. The service
interval has been reset.
To reset the reminder at a new interval:
1. Enter the service i nterval screen.
2. P ress and hold the SET button for five seconds, until the hours
begin to flash.
3. Immediat ely rel ease the button.
4. Press the button again up to five times to advance the reminder i n
50-hour increments.
NOTE: The maximum interval is 250 hours.
To disable the service interval reminder, press the SET button once
after reaching 250 hours on the display. The gauge will display
“OFF”.
To Next Page
Loading...
