40
FEATURES
MFD Battery Replacement
6. Install a new battery with fingers only.
7. Seal the end of the battery compartment using high strength
double-sided tape between the two compartment halves or high
strength single-sided tape around the outside of the compartment.
8. Make sure the taped seam of the compartment faces the downward
side of the wire harness.
9. Install a cable tie to secure the compartment to the wire harness in
the same location where the previous cable tie was located. Make
sure the battery wires are not stretched tight.
Gauge Cleaning
1. Wipe the gauge face as needed using a clean cloth and a mild soap
and water solution. Wipe dry with clean, soft cloth.
2. Clean the back side of the gauge using a clean cloth and a mild
soap and water solution. Do not remove the electrical connectors
or protective rubber boot. Do not spray the back side of the gauge
or the wire harness with a pressure washer or other water source.
CAUTION
To prevent damage to the lens, do not use alcohol for cleaning.
Do not allow chemicals or sprays to come into contact with the
lens. Immediately clean off any gasoline that splashes on the
gauge during refueling.
To Next Page
Loading...
Need help?
General
