102
MAINTENANCE
General Maintenance
n
Hydraulic Brake Inspection
Frequently inspect the brake
lever reserve. Firmly
depress the brake lever and
measure the clearance
between the lever and
handlebar grip. This
distance, called brake lever
reserve (A), should be no
less than 1/2″ (1.3 cm).
Brake pads must be replaced when the brake pad material becomes
thinner than the backing plate (approximately 1/16″). A kit is available
for replacing brake pads. S ee your dealer.
WARNING
Brake failure during operation can result in serious injury or
death. Properly functioning brakes are vital to your safety. Be
sure the brake pads do not drag on the disc and that brake lever
travel is not excessive.
Always replace brake pads when the brake pad material
becomes thinner than the backing plate (approximately 1/16″).
A
To Next Page
Loading...
