86
MAINTENANCE
Lubrication
Jackshaft Bearin g Greasing
Loosen the driven clutch ret aining bolt
and pull the clutch outward to expose the
bearing and greas e fitting. Inject grease
into the grease fitting in the flangette
until grease purges from inside or
outside the bearing seal (may take only
two pumps). Push the clutch back onto
the shaft and replace the clutch retaining
bolt. Torque to 18 ft. lbs. (24.4 Nm).
Drivesh aft Bearing Greasing
Inject grease into t he fitting on the speedometer
drive adaptor until grease purges from inside or
outside the bearing seal (approximately two
pumps).
Coupler Greasing (WideTrak)
Grease the couplers on the
driveshaft and jackshaft.
Grease points are indicated by a +.
1. Jackshaft
2. Driveshaft
3. Transmission
+
+
+
+
+
1
2
3
To Next Page
Loading...
