FINAL DRIVE
7.7
support casting on outer edges so bearing can be
removed.
4. Inspect bearing.
NOTE: Due to extremely close tolerances and
minimal wear, the bearings must be inspected
visually, and by feel. While rotating bearings by hand,
inspect for rough spots, discoloration, or corrosion.
The bearings should turn smoothly and quietly, with
no detectable up and down movement and minimal
movement sideways between inner and outer race.
5. Inspect bearing housing for scratches, wear or
damage. Replace housing if damaged.
FRONT HUB EXPLODED VIEW (4X4 & 6X6)
Disc Brake
Front Hub
Rim
Tire
Wheel Nut
Dust Cover
Slotted Nut
W asher
Cotter Pin
35 ft. lbs. (47 Nm)
40 ft. lbs. (55.0
Nm)
18 ft. lbs. (24.9 Nm)
Use new bolts with
pre-applied
locking agent.
Stud
To Next Page
Loading...
