FINAL DRIVE
7.44
Bearing Removal/Installation
20. Remove the retaining ring from the axle tube.
21. Remove the bearings from the axle tube with a
bearing puller . Inspect the bearing surface for
scoring or nicks. Spin the bearing to check the
ball bearings for smoothness. Replace the
bearing if needed.
22. Reinstall the bearing using a press.
NOTE: The bearing should be properly lubricated
before installation.
23. Reinstall the retaining ring.
REAR AXLE HOUSING
INSTALLA
TION
1. Lube the splines of the rear gearcase with
anti--seize.
2. Reinstall the axle spacer seals. Reinstall the axle
onto the rear gearcase (both sides) Reinstall the
axle tube over the axle and attach it to the
gearcase.
3. Install and tighten the four bolts onto the right side
of the gearcase. Install and tighten the two
bottom bolts to the left side of the gearcase. Do
not torque the bolts.
NOTE: The two top gearcase to tube bolts (B) on the
left side are installed into the frame later in this
assembly procedure.
4Bolts
B
To Next Page
Loading...
