FINAL DRIVE
7.45
4. Fit the rear axle assembly up to the frame. Slide the
rear driveshaft yoke onto the rear gearcase input
shaft.
Driveshaft Yoke
5. Fit the rear axle assembly up to frame. Attach the
rear axle assembly to the shocks. Leave the
shock bolts finger tight until assembly is
complete.
NOTE: Use a jack or another person to assist with the
rear axle assembly installation.
NOTE: Use caution when removing the rear axle
assembly. Extra jacks maybe needed to raise the rear
axle assembly safely.
6. Install the four U--bolts. Align the U--bolts with the
white marks previously made on the axle tube for
proper rear axle alignment.
NOTE: Use a floor jack to help align the rear axle
assembly for the U--bolt installation.
U--bolt Alignment Marks
7. Install the U--bolt nuts, but do not tighten the nuts.
8. Install the two frame to gearcase bolts (C). Torque
the gearcase bolts to 60 ft. lbs. (81 Nm) (Both
Sides).
C
60 ft.lbs. (81 Nm)
Axle Tube to Gear Case
60 ft. lbs. (81 Nm)
Bolt Torque:
To Next Page
Loading...
