Page 23
English
User Issue Possible Cause Suggested Solution
Lights on control box ash
after pressing Start/Stop
Floating cable not connected Unplug and then reconnect the oating cable to
the control box.
Cleaner not fully submerged. Remove cleaner from pool and re-submerge
(see: Install and Submerge the Cleaner).
Poor connection or need to restart
cycle.
Unplug the control box and reconnect to a GFCI
outlet. Press "Start" to begin a new cycle.
Propeller or wheels may be jammed
and not turning correctly.
Contact your local retailer to request a diagnostic
review. If the problem is not resolved, contact
Polaris Technical Support at 1-800-822-7933.
The ashing lights appear
on the control box during the
cleaning cycle.
Cleaner not fully submerged Remove cleaner from pool and re-submerge
(see: Install and Submerge the Cleaner).
The cleaner does not stay
on the pool surface or is
oating excessively.
There is air trapped inside the
cleaner housing.
Remove cleaner from pool and re-submerge
(see: Install and Submerge the Cleaner).
The lter canister is full or dirty. Dispose of debris and thoroughly clean the lter
canister with mild soap and a soft brush. Then,
re-submerge the cleaner
(see: Clean the Filter Canister).
The cleaner is not climbing
walls.
The lter canister is full or dirty. Dispose of debris and thoroughly clean the lter
canister with mild soap and a soft brush. Then,
re-submerge the cleaner (see: Clean the Filter
Canister).
Tire treads worn down See: Replacing Wear Parts
Conrm appropriate pool chemistry Speak with your pool service professional.
Do not leave cleaner in the pool during any
chemical treatments.
The cleaner is not moving Not connected to electricity. The outlet the control box is connected to, is not
supplying electrical power. Check that the outlet
to which the control box is connected is receiving
electricity.
Cycle not started. Press the Start button to initiate a cleaning cycle.
Reset needed Disconnect the unit power and reconnect after 20
seconds. If the problem is not resolved, contact
your local retailer to request a diagnostic review
or contact Polaris Technical Support at
1-800-822-7933.
The oating cable has
excessive tangling
Too much cable in the water. Place only the required amount of cable into the
water to allow it to reach the farthest end of your
pool with remaining cable on the pool deck
(see: Install and Submerge the Cleaner)
Removal needed Untangle the twisted cord and lay in sun to
reduce memory (see: Cord Tangling).
General Troubleshooting
The following list provides some helpful hints for troubleshooting common
challenges when using the cleaner.
To Next Page
Loading...
Need help?
General
