Why does my Polaris 9550 Sport not climb the pool sides?
Your Polaris Swimming Pool Vacuum might not be climbing the pool sides because the filter canister is full or dirty, so you should clean it. Also, the pool sides could be slippery due to microscopic algae. In this case, perform a shock chlorination treatment and slightly reduce the pH, but be sure to remove the cleaner from the pool during this treatment.
What to do if my Polaris 9550 Sport doesn't stay on the pool bottom?
If your Polaris Swimming Pool Vacuum isn't staying firmly on the pool bottom, it might have air trapped in the casing, so submerge the cleaner completely. Alternatively, the filter canister might be full or dirty, so clean the filter canister.
What to do if my Polaris 9550 Sport doesn't move on startup?
If your Polaris Swimming Pool Vacuum doesn't move on startup, ensure the outlet the control unit is connected to is receiving electrical power. Also, check that you have started one of the two programs and that the indicator for the selected program is lit. If the indicator light is not lit, turn the wheels then disconnect the control unit and wait at least 20 seconds before reconnecting. If the problem persists, contact Polaris Technical Support at (USA) 1-800-822-7933.
How to stop my Polaris 9550 Sport Swimming Pool Vacuum cable from tangling?
To prevent your Polaris Swimming Pool Vacuum cable from tangling, avoid unraveling the entire cable length; place only the necessary amount in the water, leaving the rest on the pool side. Also, the brushes may be worn, indicated by smoothness or a 'wear' indicator, so replace them. A full or dirty filter canister can also cause tangling, so clean the filter canister.
Why is my Polaris 9550 Sport flashing lights after starting?
If the lashing indicator lights or an error code appear on your Polaris Swimming Pool Vacuum just after starting, the floating cable may not be correctly plugged into the control unit, so unplug and reconnect it. The cleaner might also not be fully submerged, so remove it from the pool and re-submerge it. Also, try resetting the cleaner by pressing the power button OFF, then Cycle I or Cycle II to begin a new cycle. If the propellor or wheels may be jammed, contact Polaris Technical Support at (USA) 1-800-822-7933.
What does it mean when the lights are flashing on my Polaris 9550 Sport during the cleaning cycle?
If the lashing lights appear on your Polaris Swimming Pool Vacuum during the cleaning cycle, the cleaner may be sucking in air. This will cause the lights to appear after 60 seconds of air intake. Remove the cleaner from the pool and re-submerge it.
General| Pool Type | In-ground |
|---|---|
| Drive System | 4-Wheel Drive |
| Remote Control | Yes |
| Weight | 43 lbs |
| Hose Length | Not applicable |
| Warranty | 2 years |
| Dimensions | 22 x 22 x 22 inches |
| Cable Length | 70 ft |
| Features | 7-day programmable timer |
| Suitable for Pool Types | In-ground pools of all shapes and surfaces |
Guidelines to prevent electrical shock hazards during use.
Instructions for initiating the cleaner's operation cycle.
Procedures for safely stopping and removing the cleaner from the pool.
Steps to program up to seven preset cleaning cycles.
Step-by-step guide to cleaning the cleaner's filter canister.
Interpreting LED flashes to diagnose issues with 9350/P935 models.
Accessing status information for troubleshooting on 9450/9550 models.
Common problems, causes, and solutions for cleaner operation.
Explanation of error codes displayed by the control unit.
To Next Page
