149
MAINTENANCE
Procedure for Adding Oil
1. Remove seat and locate
dipstick (1).
2. Re move dipstick. Oil level
is shown on dipstick.
3. Add SAE 10W30 oil with a
transmission fluid funnel
until oil is at the proper level
on the dipstick. If over-
filled, excess oil will be ex-
pelled through the vent
hose.
4. Reinstall dipstick.
NOTE: Recommended Oil
Level (2).
Counter Balance Oil
Changing Procedure
1. Remove skid plate.
2. Remo ve counter balance
drain plug. Catch u sed oil
and discard of properly.
3. Clean and reinstall drain
plug.
4. Add 10W30 oil to full mark on dipstick. Capacity after draining
is approximately 70-75 cc (2.3 - 2.5 oz.).
5. Reinstall dipstick and check for leaks.
1
1
2