39
CONTROL AND PARTS FUNCTIONS
When the programmed hours are reached, SEr hr will light; when
the programmed distance is reached, SErdIS will light. Each time
the vehicle is started, the reminder will turn on and remain lit until
the button is pushed or the speedometer is reprogrammed for the
next service interval.
Accessing Sub-menu Featu res
There are two methods for a ccessing the sub menu:
1. Press and hold the button and turn the power on
2. Press and hold the button for 8 seconds
Hold the button until the display shows POLArS then release the
button. The speedometer is now in the sub-menu. To displayeach
mode, press the button once to scroll through the four available
functions. Each function will be displayed as follows:
Service Hours SET hr
Service Distance SETdIS
Miles to Kilometers COnvrT
No Menu Changes DOnE
Changing Distance Measuremen t
1. Access the sub-menu
2. Select COnvrT and release the button. If the last digit in the
odometer display is K, the current measurement is kilometers;
if the last digit is M, distance is being measured in miles.
To Set Service Hours
1. Access the sub--menu
2. Toggle to SET hr, then release the button.
3. In 3 seconds, the LCD will display 5 digits, with the left--most
digit flashing.
4. Within 4 seconds, pre ss and release the button to change the
digit. Once the digit is changed once, the button may be held
to scroll through the digits from 0 to 9.
5. After the digit has been selected, do not push the button. After
4 seconds the next digit will flash.
To Next Page
Loading...
Need help?
General
