40
CONTROL AND PARTS FUNCTIONS
Setting Service Hours (cont.)
6. Repeat step 4 and 5 to program the digits forthe serviceinterval
selected. (i.e. for service interval of 50 hours set the display to
show: 00050 H)
7. To save the changes press and hold the button when any one
of the digits is flashing.
8. The displaywill change to DOnE. At this time release the button
and the changes are now saved.
TO CHECK WHEN SERVICE IS DUE BY HOURS
Using the 50--hour service setting example from above, the
speedometer will take the 50--hour setting and add it to the val-
ue of the hour-- meter. This will be the value displayed when the
operator checks when service is due for the ATV. For example,
the hour meter reading is 132 hours, and the service interval
was set for 50 hours, the 5--digit display will show 182 hours.
1. Access the sub--menu
2. Toggle to SET hr , then release the button
3. In 3 seconds, the LCD will display 5 digits, with the left--most
digit flashing. As in the example above, the display would show
00182 H.
4. Either turn the power off or not touch the button for 35 seconds
to maintain the current settings.
To Next Page
Loading...
Need help?
General
