65
FEATURES AND CONTROLS
Batteries
Alternate Battery Charging Method
If the combined voltage of all batteries reaches 36 volts or less, a safety feature in the on-
board charger will not allow the charger to activate. Use the alternate charging method to add
a small charge to each battery separately. The on-board charger will then activate properly to
recharge all batteries to a full charge.
Use a 12-volt battery charger to charge 12-volt batteries. Charge each battery individually.
Use a 24-volt charger to charge 8-volt batteries. Charge in 3 groups, each consisting of 3
sequentially wired batteries.
Tip: It is not necessary to remove or disconnect battery post connections during the alternate charging
method.
To Next Page
Need help?
General
