79
FEATURES AND CONTROLS
Rear Accessory Backs (Option)
5. Rotate the release handle to release the dual latches.
6. Remove the safety strap and carefully remove the existing accessory back.
7. Install the desired accessory back onto the mounting brackets.
8. Secure the safety strap.
9. Push the accessory back forward to engage the dual latches. Make sure you hear two
clicks, one for each latch engagement. Test to make sure the latches are secure. If not
secure, repeat this step.
CAUTION! Keep the rear latch in a locked position when operating or transporting the vehicle. The
rear accessory could fall and cause injury if the safety strap is not used.
10. Always lock the release handle with the ignition key after changing accessory backs.
To Next Page
Need help?
General
