3. View the coolant level through the opening.
4. Use a funnel and slowly add coolant as needed.
5. Reinstall the pressure cap securely. Use of a non-standard pressure cap will
not allow the recovery system to function properly. Your POLARIS dealer, or
other qualified person, can provide the correct replacement part.
6. With the pressure cap securely installed, add coolant to the overflow bottle to
the recommended level. Reinstall the coolant bottle cap.
POLARIS VARIABLE TRANSMISSION (PVT)
SYSTEM
WARNING
Failure to comply with the instructions in this warning can result in severe injury
or death. Do not modify any component of the PVT system. Doing so may
reduce its strength so that a failure may occur at a high speed. The PVT
system has been precision balanced. Any modification will cause the system to
be out of balance, creating vibration and additional loads on components.
The PVT system rotates at high speeds, creating large amounts of force on
clutch components. As the owner, you have the following responsibilities for
your own safety and the safety of others:
• Always follow all recommended maintenance procedures. Always look for
and remove debris inside and around the clutch and vent system when
replacing the belt.
• See your dealer or other qualified service person as outlined in the owner's
manual.
• This PVT system is intended for use on POLARIS products only. Do not
install it in any other product.
• Always make sure the PVT housing is securely in place during operation.
BELT REPLACEMENT / DEBRIS REMOVAL
If a belt fails, always clean any debris from the duct and from the clutch and
engine compartments when replacing the belt.
WARNING
Failure to remove ALL debris when replacing the belt could result in vehicle
damage, loss of control and severe injury or death.
101
MAINTENANCE
To Next Page
Loading...
Need help?
General
