REMOVAL FROM STORAGE
WARNING
Engine exhaust contains poisonous carbon monoxide and can cause loss of
consciousness or death. Never run an engine in an enclosed area.
1. Check the battery electrolyte level and charge the battery if necessary. Install
it in the vehicle. Make sure the battery vent hose is routed properly and that
it's not pinched or restricted in any way.
2. Make sure spark plugs are tight.
3. Fill the fuel tank with fuel.
4. Check all the points listed in the Daily Pre-Ride Inspection. Tightness of the
bolts, nuts and other fasteners should be checked by an authorized dealer or
other qualified service facility.
5. Lubricate at the intervals outlined in the Periodic Maintenance Chart.
TRANSPORTING THE GENERAL
Follow these procedures when transporting the vehicle.
1. Place the transmission in PARK. Stop the engine.
2. Slowly release the brake pedal and make sure the transmission is in PARK
before exiting the vehicle.
3. Remove the key to prevent loss during transporting.
4. Secure the fuel cap, hood, doors (if equipped) and cargo box. Ensure that
the seats are attached correctly and are not loose.
WARNING
Cargo and other loose vehicle parts may fly off while transporting this vehicle.
Secure or remove all cargo, and inspect the unit for loose parts prior to
transport.
If transporting the vehicle in a non-enclosed trailer, then the vehicle must FACE
FORWARD, or roof must be removed.
Failure to comply may allow airflow, vibration, or other factors to separate the
roof from the vehicle and cause an accident, resulting in serious personal
injury or death.
5. Always tie the frame of the POLARIS vehicle to the transporting unit securely
with suitable straps or rope. Do not attach tie straps to the front A-arm bolt
pockets.
121
MAINTENANCE
To Next Page
Loading...
Need help?
General
