BRAKE LIGHTS
When the brake pedal is depressed, the brake light comes on. Check the brake
light before each ride.
To check the brake lights, do the following:
1. Turn the key to the ON position.
2. Depress the brake pedal. The brake light should come on after about 0.4 in
(10 mm) of pedal travel. If the light doesn't come on, check the electrical
connector to the brake lamp.
NOTICE
There are no serviceable components in the brake light assembly.
BATTERY
Your vehicle has a sealed battery, which requires little maintenance. Always
keep battery terminals and connections free of corrosion. If cleaning is
necessary, remove the corrosion with a stiff wire brush. Wash with a solution of
one tablespoon baking soda and one cup water. Rinse well with tap water and
dry off with clean shop towels. Coat the terminals with dielectric grease or
petroleum jelly.
BATTERY REMOVAL
WARNING
Improperly connecting or disconnecting battery cables can result in an
explosion and cause serious injury or death. When removing the battery,
always disconnect the negative (black) cable first. When reinstalling the
battery, always connect the negative (black) cable last.
1. Remove the driver’s seat to access the battery.
2. Disconnect the black (-) battery cable first. Disconnect the red (+) battery
cable last.
3. Remove the battery hold-down strap.
4. Lift the battery out of the vehicle.
BATTERY INSTALLATION
Using a new battery that has not been fully charged can damage the battery and
result in a shorter life. It can also hinder vehicle performance. Follow the battery
charging instructions on page 115 before installing the battery.
114
MAINTENANCE
To Next Page
Loading...
Need help?
General
