Polaris Hawkeye 300 2X4 User Manual (English)

Questions and Answers:

F
Frances HaynesJul 26, 2025
What to do if my Polaris Hawkeye 300 2X4 Offroad Vehicle engine stops or loses power?
- H
  hannah19Jul 26, 2025
  If your Polaris Offroad Vehicle's engine stops or loses power, the issue might stem from: * Being out of fuel. Refuel, cycle key to ON position three times for 5 seconds each, then start. * A kinked or plugged fuel vent line. Inspect and replace if equipped. * Water or old/non-recommended fuel in the fuel. Replace with fresh recommended fuel. * Overuse of choke. Inspect, clean and/or replace spark plugs. * Fouled or defective spark plug(s). Inspect, clean and/or replace spark plug(s). * Loose ignition connections. Check all connections and tighten. * Low battery voltage. Recharge the battery to 12.8 VDC. * A clogged air filter. Inspect and clean or replace. * Overheated engine. Clean engine exterior, see your Polaris dealer.
L
Laura JonesAug 1, 2025
What to do if my Polaris Offroad Vehicle engine rotates but fails to start?
- J
  Jennifer WhiteAug 1, 2025
  If your Polaris Offroad Vehicle's engine rotates but fails to start, consider these possible causes: * Out of fuel. Refuel. * Clogged fuel valve or filter. Inspect and clean or replace. * Water is present in fuel. Drain the fuel system and refuel. * Fuel valve is turned off. Turn the fuel valve on. * Old or non-recommended fuel. Replace with fresh recommended fuel. * Fouled or defective spark plug(s). Inspect plugs and replace if necessary. * No spark to spark plug. Inspect plugs, verify stop switch is on. * Overuse of choke. Inspect, clean and/or replace spark plugs. * Clogged fuel filter. Replace the filter. * Low battery voltage. Recharge the battery to 12.8 VDC.
M
Melody MyersAug 7, 2025
Why does my Polaris Hawkeye 300 2X4 Offroad Vehicle drive belt wear or burn?
- F
  foleyamyAug 7, 2025
  Drive belt wear or burn in your Polaris Offroad Vehicle can occur due to several reasons: * Driving onto a pickup or tall trailer in high range. * Starting out going up a steep incline. * Driving at low RPM or ground speed (3-7 MPH). * Insufficient warm-up at low ambient temperatures. * Slow/easy clutch engagement. * Towing/pushing at low RPM/low ground speed. * Utility use/plowing. * Stuck in mud or snow. * Belt slippage from water or snow ingestion into the PVT system. * Clutch malfunction. * Poor engine performance. * Slippage from failure to warm up belt. * Wrong or missing belt. * Improper break-in.
M
marvin82Aug 13, 2025
Why is my Polaris Hawkeye 300 2X4 Offroad Vehicle engine overheating?
- D
  David DominguezAug 13, 2025
  Your Polaris Offroad Vehicle engine might be overheating due to: * Towing/dragging heavy loads. Install the accessory oil cooler if the vehicle will be used for towing heavy loads, dragging ground surfaces or performing similar activities. * Operating in excessive heat. Install the accessory oil cooler if the vehicle is normally operated when the air temperature is above 38° C.
J
jgilesAug 19, 2025
How to troubleshoot an Polaris Offroad Vehicle when the engine does not rotate?
- M
  michaelspencerAug 19, 2025
  If the engine of your Polaris Offroad Vehicle does not rotate, check the following: * Low battery voltage: Recharge the battery to 12.8 VDC. * Loose battery connections: Check all connections and tighten. * Loose solenoid connections: Check all connections and tighten.