102
MAINTENANCE AND LUBRICATION
Adjustments
Oil Pump - 250 Engines
1. Before adjusting the oil pump, check the
engine idle R PM and carburetor settings
in the owner’s manual supplement.
2. Loosen throttle cable jam nut and turn
the adjuster (1) in or out until there is
1/16″ -1/8″ (.16 - .32 cm) of throttle
lever travel before t he throttle slide starts
to open. See your owner’s manual
supplement.
3. Place very slight pressure on the throttle
lever (2) until all freeplay is removed
from the throttle cable (to t he point
where the carb slide is just starting to
rise).
4. Loosen the locknut (3).
Turn the adjuster in or out
until all freeplay is removed
from the oil pump cable (the
point where the oil pump
arm is just starting to move
off its stop). The pump stop
keeps the pump arm from
rotating any further down
than the idle position so no
visual alignment of marks is
necessary. Tighten the
locknut.
2
3
1
3
To Next Page
Loading...
